Pumps Tanks Motors &    Switches

Submersible Pumps Three & Four Inch, Jet Pumps, Centrifugal & Booster Pumps

Tanks & Cycle Stop Valves

Motors, Motor Protection, Flow & Float Switches

Water Filtration, Water Well Accessories

Sump & Sewage Pumps

Swimming Pool Pumps

Pond Pumps

 

Site Info

THE NEW OASIS PUMPS


Shopping Cart & PricingPricing can be seen on the Shopping Cart. Clicking a product image will also take you there.

*Free Shipping on orders of $500.00 or more!   Continental US and ground only!


The rugged, cost-efficient Oasis hand-lift pump combines all the advantages of the old fashioned cast iron pump with modern  technology. Made of Reinforced Engineering Thermoplastics, the Oasis Pump is virtually  unbreakable, lightweight and will not rust, corrode or wear.  Tests show no wear  of the cylinder or plunger cup after millions of strokes.

Closed design prevents entry of air-borne and other potential contaminants,  an important consideration for a sanitary water supply.

It is ideal for monitoring wells; test wells; as a bilge pump; as a transfer  pump or any general purpose pumping application. It will pump most any liquid,  and is very useful any place where water has to be carried, pumped or  hauled.

The Oasis Pump is used primarily on wells, cisterns, springs, buried tanks,  rivers or streams where maximum lift (distance to water) does not exceed 25  feet  unless using deep well model.

With its lightweight, sturdy construction the Oasis Pump is ideal for  campsites, summer homes, stock water, rural dwellings, parks, picnic areas,  plant nurseries, villages or remote locations.

GENERAL SPECIFICATIONS (ALL MODELS)
Discharge 1 1/2 in. Suction 2 in. or 1  1/4 in. Height 18 in. Weight 4 pounds.  Diameter 3 1/2 in. (3 in. I.D.  cylinder). Resistant to salt water, most chemicals. Up to 10 gallons per minute.  Maximum Lift (distance to water) 25 ft.

AVAILABLE IN 3 MODELS

Model No. W1 - A conventional hand pump for general purpose pumping  applications open discharge.

Model No. WP2 - A pressure version of the W1 with pressure capability. Will  plumb directly to standard PVC pipe (solvent weld) or adapt to hose, etc.  0-20lbs. normal operating pressure, up to 50 ft. head.

Model No. WP2D & DC280 DEEP WELL KIT -  Oasis pump and cylinder  combination uses PVC for lift rod allowing for less effort on each stroke due to  the hollow PVC pipe aiding in lift. This is why this light weight and small pump  is able to pump at the depths far below 100 feet.

THIS MODERN DURABLE PUMP

With a new plunger of our own design and other patented features, you can  produce 1/3 more volume than a conventional hand pump the same size.

The new cup molded from a Polyester Elastomer will not wear, distort or dry  out and is bacterial inert, resistant to rot, mildew, corrosion, salt water and  most chemicals.

This new cup may be used as a replacement item on any standard 2-3 in.  plunger.

WEIGHT CONSIDERATION:

The pumps weight per volume factor is unmatched. A 4lb. shipping weight  compared to 20lb. plus on cast iron...consider the freight savings.

At less than 1/5 the cost, this is a primary consideration.


 

Helpful Information

We will answer any questions you may have about water systems, filtration, problems with equipment etc. Just Contact Us at Pumps And Tanks or visit the Pumps and Tanks Forum

To order call: 813-677-7867 (PUMP)
Mon - Friday 8:30 to 5:00 est. Saturdays 9:00 to Noon

*  Free shipping for items on the shopping cart only.


9431 Hwy 301 S.
Riverview, FL 33569
813-677-PUMP (7867)

Copyright 2008 © Pumps And Tanks - All Rights Reserved.

Visit us, email us or give us a call. We are here to help.